Car configurator
Show tuning systems

FAQ

Here you can find the frequently asked questions:
 


The IOPEDAL has an official type approval issued by the Kraftfahrt-Bundesamt (German Federal Motor Transport Authority) according to ECE regulations/directives 2014/30/EU (EMC) of the United Nations Economic Commission for Europe. The component marked with the approval number may be operated in Germany and many other international countries without a special entry in the vehicle documents. In Germany, the recognition of the E-marking is regulated in § 21a of the StVZO.


The IOPEDAL is designed for vehicles with any type of engine in mind. It is possible to use the IOPEDAL in combination with combustion engines, fully electric and hybrid vehicles. The IOEPDAL is also future-proof and can handle all common accelerator pedal signals currently used on the market (analog, PWM and also digital SENT signals).

Configure your vehicle now


The IOPEDAL is highly customizable and has many predefined tuning characteristics. A "Flavor" contains all the similar characteristics. For example, in every "Flavor" there is a trafficMode, ecoMode, sportMode, xtremeMode and valetMode specifically configured for this flavor. Each mode in turn also contains another 5 specific sub-programs. The delivery state of the module is Normal.

Normal - delivery state - Balanced settings.
Power - All programs have a more pronounced characteristic.
Precise - All programs allow for more control.


There are 2 good reason for this. Wired types of pedal tuning don't allow for flexible installation and always have a visible cable running through your cockpit. Using an app on your mobile phone to control your pedal tuning is hard and dangerous while driving and prohibited in a lot of countries.


In our experience, the manufacturer's warranty remains unaffected by the use of a gas pedal tuning, as the engine performance of the vehicle remains unchanged. However, we cannot make any binding statement in this regard. When in doubt, you can inquire your vehicle's manufacturer.
 

Yes. The installation is relatively simple and can be done in just a few steps. Have a look on our installation page for instructions.

Continue to installation


Yes. When your new vehicle uses the same loom only a reset of the module is needed. You can find instructions on how to do this in the manual. If your current loom isn't compatible with your new vehicle, you'll first have to order a new loom. The best way to do this is to contact us by e-mail: support@iotuning.com


The remote controller is powered by a conventional CR2032 coin cell battery.


Battery life was a key component in the development of the remote controller. The battery is expected achieve an operating time of 12 months with normal daily use.


Changing the battery is very easy. You can open the housing with the included Torx screwdriver and then replace the battery directly. 
A CR2032 battery should be available in any well-stocked supermarket. For more information consult the user manual or contact us.



Instruction manual   (1.69 MB) :